Wednesday, December 10, 2014

Open-sourced DSO (Digital Storage Oscilloscope) DIY kit - DSO138

Interesting open-sourced digital oscilloscope DIY kit, DSO138, think about buying one. But I can't find the source in the web-site, and instruction to flash the firmware!



http://www.jyetech.com/Products/LcdScope/e138.php

DSO138 was designed as a training oscilloscope kit. It contains only the basical oscilloscope functions with no fancy features. Simplicity in structure and easiness in assembly/operation are among the main targets of the design. For these purpose DSO138 uses mostly through-hole parts. The heart of DSO138 is a Cortex-M3 ARM processor (STM32F103C8) from ST. It uses 2.4-inch TFT LCD (320 X 240 dotmatrix, 262K colors) as its display element and displays nice and clear waveforms. Detailed assembly instructions are provided in combination with troubleshooting guide and schematc. Source codes are also available to allow user to add their own features.

DSO138 kits are solded in two configurations. One is with all SMD parts pre-soldered (PN: 13801K). The other is with only the main IC (the MCU) pre-soldered (PN: 13802K). The latter serves also as a SMD soldering training kit. For both configurations the MCU has been pre-programmed and no re-programming required.

DSO138 is partially open-sourced. This opens the possibility for users to add different features or develop new applications on the hardware.

Major features of DSO138: 
  • Analog bandwidth: 0 - 200KHz
  • Sampling rate: 1Msps max
  • Sensitivity: 10mV/Div - 5V/Div
  • Sensitivity error: < 5%
  • Vertical resolution: 12-bit
  • Timebase: 10us/Div - 500s/Div
  • Record length: 1024 points
  • Built-in 1KHz/3.3V test signal
  • Waveform frozen (HOLD) function available


Updated:
Finally I bought my own DSO138 kit, read Assemble, test, align and power-up DSO138, Open-sourced Oscilloscope DIY kit.

No comments:

Post a Comment